ip igmp static-groupConfigure an IGMP static group.S4810Syntax ip igmp static-group {group address [exclude [source address]]| [include {source address}]}To delete a static address, use the no ip igmp static-group {groupaddress [exclude [source address]] | [include {sourceaddress}]} command.Parameters group address Enter the group address in dotted decimal format (A.B.C.D).exclude sourceaddress(OPTIONAL) Enter the keyword exclude then the sourceaddress, in dotted decimal format (A.B.C.D), for which astatic entry is added.include sourceaddress(OPTIONAL) Enter the keyword include then the sourceaddress, in dotted decimal format (A.B.C.D), for which astatic entry is added.Defaults noneCommandModesINTERFACECommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.Version 7.5.1.0 Expanded to support the exclude and include options.E-Series legacycommandUsageInformationA group in include mode must have at least one source address defined. Inexclude mode, if you do not specify a source address, Dell Networking OSInternet Group Management Protocol (IGMP) 719
