Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.E-Series legacycommandsnmp-server enable trapsEnable SNMP traps.S4810Syntax snmp-server enable traps [notification-type] [notification-option]To disable traps, use the no snmp-server enable traps [notification-type] [notification-option] command.Parameters notification-typeEnter the type of notification from the following list:• bgp — Notification of changes in the BGP process.• config — Notification of changes to the startup orrunning configuration.• ecfm — Notification of changes to ECFM.• ecmp — Enable an ECMP trap to notify of ECMP or linkbundle traffic imbalances.• envmon — For Dell Networking device notifications whenan environmental threshold is exceeded.• isis — Notification of intermediate service traps.• lacp — Notification of changes.• snmp — Notification of RFC 1157 traps.• stp — Notification of a state change in the spanning treeprotocol (RFC 1493).• vlt — Notification of virtual link trunking.• vrrp — Notification of a state change in a VRRP group.• xstp — Notification of a state change in MSTP (802.1s),RSTP (802.1w), and PVST+.notification-optionFor the envmon notification-type, enter one of the followingoptional parameters:• cam-utilization• fan1562 Simple Network Management Protocol (SNMP) and Syslog
