UsageInformationThe buffer-profile global command fails if you have already applied acustom buffer-profile on an interface. Similarly, when you configure buffer-profile global, you cannot not apply buffer-profile on any interface.If the default buffer-profile is active, Dell Networking OS displays an error messageinstructing you to remove the default configuration using the no buffer-profile global command.Reload the system for the global buffer-profile to take effect.Hardware CommandsThese commands display information from a hardware sub-component or ASIC.clear hardware stack-unitClear statistics from selected hardware components.S4810Syntax clear hardware stack-unit id {counters | unit 0–0 counters |cpu data-plane statistics | cpu i2c statistics | cpu party-busstatistics | cpu sata-interface statistics | stack-port 0–127}Parameters stack-unit id Enter the keywords stack-unit then a number to select aparticular stack member and then enter one of the followingcommand options to clear a specific collection of data. Therange is 0 to 11 for the S4810.counters Enter the keyword counters to clear the counters on theselected stack member.unit numbercountersEnter the keyword unit along with a port-pipe number,then the keyword counters to clear the counters on theselected port-pipe. The range is 0 to 0 for the S4810.cpu data-planestatisticsEnter the keywords cpu data-plane statistics to clearthe data plane statistics.cpu party-busstatisticsEnter the keywords cpu party-bus statistics to clearthe management statistics.stack-port Enter the keywords stack-port then the port number ofthe stacking port to clear the statistics of the particularstacking port. The range is 0 to 63 for the S4810.Defaults none596 Debugging and Diagnostics
