implicitly assumes all sources are included. If you do not specify either include orexclude, Dell Networking OS implicitly assumes a IGMPv2 static join.Command Limitations• Only one mode (include or exclude) is permitted per multicast group perinterface. To configure another mode, all sources belonging to the originalmode must be unconfigured.• If a static configuration is present and a packet for the same group arrives on aninterface, the dynamic entry completely overwrites all the static configurationfor the group.RelatedCommandsshow ip igmp groups — displays IGMP group information.ip igmp versionManually set the version of the router to IGMPv2 or IGMPv3.S4810Syntax ip igmp version {2 | 3}Parameters 2 Enter the number 2 to set the IGMP version number toIGMPv2.3 Enter the number 3 to set the IGMP version number toIGMPv3.Defaults 2 (that is, IGMPv2)CommandModesINTERFACECommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version 9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.720 Internet Group Management Protocol (IGMP)
