debug ip msdpTurn on MSDP debugging.S4810Syntax debug ip msdp {event peer address | packet peer address | pim}To turn debugging off, use the no debug ip msdp {event peer address |packet peer address | pim} command.Parameters event peeraddressEnter the keyword event then the peer address in a dotteddecimal format (A.B.C.D.).packet peeraddressEnter the keyword packet then the peer address in a dotteddecimal format (A.B.C.D.).pim Enter the keyword pim to debug advertisement from PIM.Defaults Not configured.CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 6.2.1.1 Introducedip msdp cache-rejected-saEnable an MSDP cache for the rejected source-active entries.S4810Syntax ip msdp cache-rejected-sa {number}To clear the MSDP rejected source-active entries, use the no ip msdp cache-rejected-sa {number} command then the ip msdp cache-rejected-sa{number} command.Multicast Source Discovery Protocol (MSDP) 1103
