interface, only the no ip address and no shutdown statements must belisted in the show config output.When you enter the switchport command, the interface is automatically addedto the default VLAN.To use the switchport backup interface command on a port, first enter theswitchport command. For more information, refer to the “ConfiguringRedundant Links” section in the “Layer 2” chapter of the Dell Networking OSConfiguration Guide.RelatedCommandsinterface port-channel — creates a port channel interface.show interfaces switchport — displays information about switchport interfaces.Egress Interface Selection (EIS) CommandsThe following commands are Egress Interface Selection (EIS) commands.applicationConfigure the management egress interface selection.S4810Syntax application {all | application-type}To remove a management application configuration, use the no application{all | application-type} command.Parameters application-typeEnter any of the following keywords:• For DNS, enter the keyword dns.• For FTP, enter the keyword ftp.• For NTP, enter the keyword ntp.• For Radius, enter the keyword radius.• For sFlow collectors, enter the keyword sflow-collector.• For SNMP (traps and MIB responses), enter the keywordssnmp .• For SSH, enter the keyword ssh .• For Syslog, enter the keyword syslog.• For TACACS, enter the keyword tacacs.• For Telnet, enter the keyword telnet.• For TFTP, enter the keyword tftp.Interfaces 797
