Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.pre-Version6.2.1.1Introduced on the E-Series.redistribute ospfRedistribute routing information from an OSPF process.S4810Syntax redistribute ospf process-id [match external {1 | 2} | matchinternal | metric metric-value] [route-map map-name]To disable redistribution, use the no redistribute ospf process-id [matchexternal {1 | 2} | match internal | metric metric-value][route-map map-name] command.Parameters process-id Enter a number that corresponds to the OSPF process ID toredistribute. The range is from 1 to 65355.match external{1 | 2}(OPTIONAL) Enter the keywords match external then thenumbers 1 or 2 to indicated that external 1 routes or external2 routes should be redistributed.match internal (OPTIONAL) Enter the keywords match internal toindicate that internal routes should be redistributed.metric metric-value(OPTIONAL) Enter the keyword metric then a number asthe metric value. The range is from 0 to 16.route-mapmap-name(OPTIONAL) Enter the keywords route-map then the nameof a configured route map.Defaults Not configured.CommandModesROUTER RIPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.1400 Routing Information Protocol (RIP)
