Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced on the E-Series.RelatedCommandsshow ip interface — displays the interface routing status and configuration.ip routeAssign a static route to the switch.S4810Syntax ip route [vrf vrf-name] ip-address mask {ip-address | interface[ip-address]} [distance] [permanent] [tag tag-value] [vrf vrf-name]To delete a specific static route, use the no ip route destination maskcommand.To delete all routes matching a certain route, use the no ip routedestination mask command.Parameters vrf vrf-name (Optoinal) Enter the keyword vrf and then the name of theVRF to configure a static route corresponding to that VRF.Use this VRF option after the ip route keyword toconfigure a static route on that particular VRF.destination Enter the IP address in dotted decimal format of thedestination device.mask Enter the mask in the slash prefix format (/x) of thedestination IP address.ip-address Enter the IP address of the forwarding router in dotteddecimal format.interface ip-addressEnter the keyword interface then the IP address.distance (OPTIONAL) Enter the value of the distance metric assignedto the route. The range is from 1 to 255.permanent (OPTIONAL) Enter the keyword permanent to specify thatthe route must not be removed even if the interface assignedto that route goes down. The route must be currently activeto be installed in the routing table. If you disable theinterface, the route is removed from the routing table.864 IPv4 Routing
