CommandModesEXEC PrivilegeCommandHistory Version 9.4.(0.0)Added support for VRF.Version 8.5.1.0 Added support for the 4-port 40G line cards on ExaScale.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Example Dell#show ip access-lists L3-ACL vrf VRF2 inStandard Ingress IP access list L3-ACL on VRF2seq 5 permit 10.1.2.0/24seq 10 permit 20.1.2.0/24Dell#show ip access-lists vrf VRF2 inStandard Ingress IP access list L3-ACLseq 5 permit 10.1.2.0/24seq 10 permit 20.1.2.0/24Dell#show ip access-lists test inStandard Ingress IP access list testseq 5 permit 1.1.1.0/24 count (0 packets)seq 10 deny 2.1.1.0/24 count (0 packets)Standard IP ACL CommandsWhen you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects animplicit permit.The S4810 supports both Ingress and Egress IP ACLs.NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commandssections.denyTo drop packets with a certain IP address, configure a filter.S4810Syntax deny {source | any | host {ip-address}}To remove this filter, you have two choices:• Use the no seq sequence-number command if you know the filter’ssequence number.Access Control Lists (ACL) 213
