CommandModesROUTE-MAPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.pre-Version6.1.1.0Introduced on the E-Series.match route-typeTo match routes based on the how the route is defined, configure a filter.S4810Syntax match route-type {external [type-1 | type-2] | internal |level-1 | level-2 | local}To delete a match, use the no match route-type {local | internal |external [type-1 | type-2] | level-1 | level-2} command.Parameters external[type-1| type-2]Enter the keyword external then either type-1 or type-2 tomatch only on OSPF Type 1 routes or OSPF Type 2 routes.internal Enter the keyword internal to match only on routesgenerated within OSPF areas.level-1 Enter the keyword level-1 to match IS-IS Level 1 routes.level-2 Enter the keyword level-2 to match IS-IS Level 2 routes.local Enter the keyword local to match only on routes generatedwithin the switch.Defaults Not configured.CommandModesROUTE-MAPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.Access Control Lists (ACL) 279
