Defaults All interfaces in Layer 2 mode are untagged.CommandModesINTERFACE VLANCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.UsageInformationWhen you use the no tagged command, the interface is automatically placed inthe Default VLAN as an untagged interface unless the interface is a member ofanother VLAN. If the interface belongs to several VLANs, remove it from all VLANsto change it to an untagged interface.Tagged interfaces can belong to multiple VLANs, while untagged interfaces canonly belong to one VLAN at a time.RelatedCommandsinterface vlan — configures a VLAN.untagged — specifies which interfaces in a VLAN are untagged.track ipTrack the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.S4810Syntax track ip interfaceTo remove the tracking feature from the VLAN, use the no track ip interfacecommand.Parameters interface Enter the following keywords and slot/port or numberinformation:Layer 2 1055
