RelatedCommandsinterface vlan — configures a VLAN.tagged — specifies which interfaces in a VLAN are tagged.Far-End Failure Detection (FEFD)The Dell Networking operating software supports far-end failure detection (FEFD) on the Ethernetinterfaces of the S4810 platform.The FEFD feature detects and reports far-end link failures.• FEFD is not supported on the Management interface.• During an RPM failover, FEFD is operationally disabled for approximately 8 to 10 seconds.• By default, FEFD is disabled.debug fefdEnable debugging of FEFD.S4810Syntax debug fefd {events | packets} [interface]To disable debugging of FEFD, use the no debug fefd {events | packets}[interface] command.Parameters events Enter the keyword events to enable debugging of FEFDstate changes.packets Enter the keyword packets to enable debugging of FEFD toview information on packets sent and received.interface (OPTIONAL) Enter the following keywords and slot/port ornumber information:• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE then the slot/ port information.CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.1058 Layer 2
