Defaults Disabled (that is, paths/routes for the same destination but from different ASs donot have their MEDs compared).CommandModesROUTER BGPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.UsageInformationIn Non-Deterministic mode, paths are compared in the order in which they arrive.This method can lead to Dell Networking OS choosing different best paths from aset of paths, depending on the order in which they are received from the neighborsbecause MED may or may not get compared between adjacent paths. InDeterministic mode (no bgp non-deterministic-med), Dell Networking OScompares MED between adjacent paths within an AS group because all paths in theAS group are from the same AS.When you change the path selection from Deterministic to Non-Deterministic, thepath selection for the existing paths remains Deterministic until you enter theclear ip bgp command to clear existing paths.bgp recursive-bgp-next-hopEnable next-hop resolution through other routes learned by BGP.S4810Syntax bgp recursive-bgp-next-hopTo disable next-hop resolution, use the no bgp recursive-bgp-next-hopcommand.Defaults EnabledCommandModesROUTER BGP394 Border Gateway Protocol
