Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.1Introduced on the E-Series.UsageInformationThe distribute-list out command applies to routes autonomous systemboundary routers (ASBRs) redistributes into OSPF. It can be applied to external type2 and external type 1 routes, but not to intra-area and inter-area routes.fast-convergenceThis command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid routecomputation so that convergence takes less time.S4810Syntax fast-convergence {number}To cancel fast-convergence, use the no fast convergence command.Parameters number Enter the convergence level desired. The higher thisparameter is set, the faster OSPF converge takes place. Therange is from 1 to 4.Defaults none.CommandModesROUTER OSPFCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on all platforms.UsageInformationThe higher this parameter is set, the faster OSPF converge takes place.NOTE: The faster the convergence, the more frequent the route calculationsand updates. This behavior impacts CPU utilization and may impact adjacencystability in larger topologies.Open Shortest Path First (OSPFv2 and OSPFv3) 1163
