Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.2.1.0 Introduced on the C-Series.Version 7.4.1.0 Introduced.UsageInformationThis command causes the Ring Manager to take ownership of the two ports afterIFM validates the configuration. Ownership is relinquished for a port only when theinterface does not play a part in any control VLAN, that is, the interface does notbelong to any ring.RelatedCommandsshow frrp — displays the Resilient Ring Protocol configuration information.member-vlanSpecify the member VLAN identification numbers.S4810Syntax member-vlan {vlan-range}To return to the default, use the no member-vlan [vlan-range] command.Parameters vlan-range Enter the member VLANs using VLAN IDs (separated bycommas), a range of VLAN IDs (separated by a hyphen), asingle VLAN ID, or a combination. For example: VLAN IDs(comma-separated): 3, 4, 6. Range (hyphen-separated):5-10. Combination: 3, 4, 5-10, 8.Defaults noneCommandModesCONFIGURATION (conf-frrp)CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version 8.3.11.1 Introduced on the Z9000.Force10 Resilient Ring Protocol (FRRP) 675
