The following is a list of the Dell Networking OS version history for this command.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.3.2.0 Introduced on the E-Series TeraScale, C-Series, and S-Series.UsageInformationBy default, all prefixes configured as addresses on the interface are advertised. Thiscommand allows control over the individual parameters per prefix; you can use thedefault keyword to use the default parameters for all prefixes. If a prefix has beenconfigured with lifetime parameter values, the default values cannot be appliedusing the ipv6 nd prefix default no-autoconfig command.ipv6 routeEstablish a static IPv6 route.S4810Syntax ipv6 route ipv6-address prefix-length {ipv6-address | interface| interface ipv6-address} [distance] [tag value] [permanent]To remove the IPv6 route, use the no ipv6 route ipv6-address prefix-length {ipv6-address | interface | interface ipv6-address}[distance] [tag value] [permanent] command.Parameters ipv6-addressprefix-lengthEnter the IPv6 address in the x:x:x:x::x format then the prefixlength in the /x format. The range is from /0 to /128.NOTE: The :: notation specifies successive hexadecimalfields of zeros.interface (OPTIONAL) Enter the following keywords and slot/port ornumber information:• For a loopback interface, enter the keyword loopbackthen a number from zero (0) to 16383.• For the null interface, enter the keyword null then zero(0).• For a port channel interface, enter the keyword port-channel then the port channel number. The range isfrom 1 to 128.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE then the slot/port information.928 IPv6 Basics
