19Force10 Resilient Ring Protocol (FRRP)Force10 resilient ring protocol (FRRP) is supported on Dell Networking S4810 platform.FRRP is a proprietary protocol for that offers fast convergence in a Layer 2 network without having to runthe spanning tree protocol (STP). The resilient ring protocol is an efficient protocol that transmits a high-speed token across a ring to verify the link status. All the intelligence is contained in the master node withpractically no intelligence required of the transit mode.Important Points to Remember• FRRP is media- and speed-independent.• FRRP is a Dell Networking proprietary protocol that does not interoperate with any other vendor.• Spanning Tree must be disabled on both primary and secondary interfaces before Resilient Ringprotocol is enabled.• A VLAN configured as the control VLAN for a ring cannot be configured as a control or member VLANfor any other ring.• Member VLANs across multiple rings are not supported in Master nodes.• If multiple rings share one or more member VLANs, they cannot share any links between them.• Each ring can have only one Master node; all others are Transit nodes.clear frrpClear the FRRP statistics counters.S4810Syntax clear frrp [ring-id]Parameters ring-id (Optional) Enter the ring identification number. The range isfrom 1 to 255.Defaults noneCommandModesEXECCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.670 Force10 Resilient Ring Protocol (FRRP)
