Version8.3.12.0Introduced on the S4810.Version8.3.16.0Introduced on MXL 10/40GbE Switch IO Module.UsageInformationYou can configure iSCSI TLVs to send either globally or on a specified interface.The interface configuration takes priority over global configuration.advertise dcbx-appln-tlvOn a DCBX port with a manual role, configure the application priority TLVs advertised on the interface toDCBX peers.S4810Syntax advertise dcbx-appln-tlv {fcoe | iscsi}To remove the application priority TLVs, use the no advertise dcbx-appln-tlv {fcoe | iscsi} command.Parameters {fcoe | iscsi} Enter the application priority TLVs, where:• fcoe: enables the advertisement of FCoE in applicationpriority TLVs.• iscsi: enables the advertisement of iSCSI in applicationpriority TLVs.Defaults Application priority TLVs are enabled to advertise FCoE and iSCSI.CommandModesPROTOCOL LLDPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version8.3.12.0Introduced on the S4810.Version8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.UsageInformationTo disable TLV transmission, use the no form of the command; for example, noadvertise dcbx-appln-tlv iscsi.554 Data Center Bridging (DCB)
