Defaults Disabled.CommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.2.1.0 Introduced on S-Series Stacking.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.7.1.0 Introduced on the S-Series.Version 7.6.1.0 Introduced on the C-Series.Version 7.4.1.0 Introduced on the E-Series.UsageInformationDell Networking OS enhances the sflow implementation for real time trafficanalysis on the E-Series to provide extended gateway information in cases wherethe destination IP addresses are learned by different routing protocols and forcases where the destination is reachable over ECMP.RelatedCommandsshow sflow — displays the sFlow configuration.sflow polling-interval (Global)Set the sFlow polling interval at a global level.S4810Syntax sflow polling-interval interval valueTo return to the default, use the no sflow polling-interval intervalcommand.Parameters interval value Enter the interval value in seconds. The range is from 15 to86400 seconds. The default is 20 seconds.Defaults 20 secondssFlow 1547
