fcoe priority-bitsConfigure the FCoE priority advertised for the FCoE protocol in application priority TLVs.S4810Syntax fcoe priority-bits priority-bitmapTo remove the configured FCoE priority, use the no fcoe priority-bitscommand.Parameters priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.Defaults 0x8CommandModesPROTOCOL LLDPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version8.3.12.0Introduced on the S4810.Version8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.UsageInformationThis command is available at the global level only.iscsi priority-bitsConfigure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.S4810Syntax iscsi priority-bits priority-bitmapTo remove the configured iSCSI priority, use the no iscsi priority-bitscommand.Parameters priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.Defaults 0x10Data Center Bridging (DCB) 559
