UsageInformationThe following describes the show ip bgp paths community command shownin the following example.Field DescriptionAddress Displays the internal address where the path attribute isstored.Hash Displays the hash bucket where the path attribute is stored.Refcount Displays the number of BGP routes using thesecommunities.Community Displays the community attributes in this BGP path.Example Dell#show ip bgp paths communityTotal 2 communitiesRefcount Community1 NO-ADVERTISE1 200:1 1000:1 3000:1show ip bgp peer-groupAllows you to view information on the BGP peers in a peer group.S4810Syntax show ip bgp [vrf vrf-name] [ipv4 unicast] peer-group [peer-group-name [detail | summary]]Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf to view information onBGP peers in a peer group corresponding to that VRF.NOTE: You can use this attribute to view information onBGP peers in a peer group that correspond to either adefault or a non-default VRF.ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to viewinformation only related to ipv4 unicast routes.peer-group-name(OPTIONAL) Enter the name of a peer group to viewinformation about that peer group only.detail (OPTIONAL) Enter the keyword detail to view detailedstatus information of the peers in that peer group.summary (OPTIONAL) Enter the keyword summary to view statusinformation of the peers in that peer group. The output is thesame as that found in the show ip bgp summarycommand.CommandModes • EXEC• EXEC PrivilegeBorder Gateway Protocol 475
