Version 7.8.1.0 Introduced on the C-Series.Version 7.4.1.0 Introduced on the E-Series TeraScale. Added the monitoroption.permitTo configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, orUDP.S4810Syntax permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}To remove this filter, you have two choices:• Use the no seq sequence-number command syntax if you know the filter’ssequence number• Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp |udp} commandParameters ip-protocol-numberEnter an IPv6 protocol number. The range is from 0 to 255.icmp Enter the keyword icmp to filter internet Control MessageProtocol version 6.ipv6 Enter the keyword ipv6 to filter any internet Protocolversion 6.tcp Enter the keyword tcp to filter the Transmission Controlprotocol.udp Enter the keyword udp to filter the User Datagram Protocol.Defaults Not configured.CommandModesACCESS-LISTCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.IPv6 Access Control Lists (IPv6 ACLs) 911
