When you apply a default route to a BGP peer or peer group using the neighbordefault-originate command, changes to the configured default route-mapare applied to the BGP peer or peer group only after a delay of 15 seconds. As aresult, you must wait for a period of 15 seconds before manually resetting BGPusing the clear ip bgp command.In case of eBGP, the neighbor default-originate command does notsupport extended-community as a non-transtive route-map attribute.You cannot set this configuration for a peer that is associated with a peer group.Similarly, you cannot associate a peer to a peer group if that peer is alreadyconfigured with these settings.In order that settings corresponding to the neighbor default-originatecommand take effect, you must execute the clear ip bgp commandimmediately after you execute the neighbor default-originate command.neighbor descriptionAssign a character string describing the neighbor or group of neighbors (peer group).S4810Syntax neighbor {ip-address | peer-group-name} description textTo delete a description, use the no neighbor {ip-address | peer-group-name} description command.Parameters ip-address Enter the IP address of the neighbor in dotted decimalformat.peer-group-nameEnter the name of the peer group.text Enter a continuous text string up to 80 characters.Defaults Not configured.CommandModesROUTER BGPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.418 Border Gateway Protocol
