Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.pre-Version7.7.1.0Introduced.RelatedCommandspolicy-map-input — creates an input policy map.policy-map-output — creates an output policy map.qos-policy-input — creates an input QoS-policy on the router.qos-policy-output — creates an output QoS-policy on the router.wred-profile — creates a WRED profile.match ip access-groupConfigure match criteria for a class map, based on the access control list (ACL).NOTE: IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-any class-maps on both ACLs as well as VLANs.S4810Syntax match ip access-group access-group-name [set-ip-dscp value |set-color value]To remove ACL match criteria from a class map, use the no match ip access-group access-group-name [set-ip-dscp value | set-color value]command.Parameters access-group-nameEnter the ACL name whose contents are used as the matchcriteria in determining if packets belong to the class theclass-map specifies.set-ip-dscpvalue(OPTIONAL) Enter the keywords set-ip-dscp then the IPDSCP value. The matched traffic is marked with the DSCPvalue. The range is from 0 to 63.set-color value (Optional) Enter the keyword set-color followed by a colorvalue. Traffic that fulfills the match criteria is marked with thecolor value that you specify. The default value is Yellow.Defaults noneCommandModesCLASS-MAP CONFIGURATION (config-class-map)1338 Quality of Service (QoS)
