log-adjacency-changesTo send a Syslog message about changes in the OSPF adjacency state, set Dell Networking OS.S4810Syntax log-adjacency-changesTo disable the Syslog messages, use the no log-adjacency-changescommand.Defaults Disabled.CommandModesROUTER OSPFCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Added support for Multi-Process OSPF.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.1Introduced on the E-Series.maximum-pathsEnable the software to forward packets over multiple paths.S4810Syntax maximum-paths numberTo disable packet forwarding over multiple paths, use the no maximum-pathscommand.Parameters number Specify the number of paths. The range for OSPFv2 is from 1to 64. The default for OSPFv2 is 4 paths. The range forOSPFv3 is from 1 to 64. The default for OSPFv3 is 8 paths.Open Shortest Path First (OSPFv2 and OSPFv3) 1177
