Version 7.7.1.0 Introduced on the C-Series.UsageInformationTo remove all configured debug commands for BGP, enter the no debug ip bgpcommand.default-metricAllows you to change the metric of redistributed routes to locally originated routes. Use this commandwith the redistribute command.S4810Syntax default-metric numberTo return to the default setting, use the no default-metric command.Parameters number Enter a number as the metric to be assigned to routes fromother protocols. The range is from 1 to 4294967295.Defaults 0CommandModesROUTER BGPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.UsageInformationThe default-metric command in BGP sets the value of the BGPMULTI_EXIT_DISC (MED) attribute for redistributed routes only.RelatedCommandsbgp always-compare-med — enables comparison of all BGP MED attributes.redistribute — redistributes routes from other routing protocols into BGP.410 Border Gateway Protocol
