CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.UsageInformationTo remove all configured debug commands for BGP, enter the no debug ip bgpcommand.debug ip bgp keepalivesDisplay information about BGP keepalive messages.S4810Syntax debug ip bgp [ip-address | peer-group peer-group-name]keepalives [in | out]To disable debugging, use the no debug ip bgp [ip-address | peer-grouppeer-group-name] keepalives [in | out] command.Parameters ip-address (OPTIONAL) Enter the IP address of the neighbor in dotteddecimal format.peer-grouppeer-group-name(OPTIONAL) Enter the keyword peer-group then the nameof the peer group.in (OPTIONAL) Enter the keyword in to view only inboundkeepalive messages.out (OPTIONAL) Enter the keyword out to view only outboundkeepalive messages.CommandModesEXEC Privilege406 Border Gateway Protocol
