pre-Version6.1.1.0Introduced on the E-Series.set tagTo specify a tag for redistributed routes, configure a filter.S4810Syntax set tag tag-valueTo delete a setting, use the no set tag command.Parameters tag-value Enter a number as the tag. The range is from zero (0) to4294967295.Defaults Not configured.CommandModesROUTE-MAPCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced on the E-Series.RelatedCommandsset automatic-tag — computes the tag value of the route.set level — specifies the OSPF area for route redistribution.set metric — specifies the metric value assigned to redistributed routes.set metric-type — specifies the route type assigned to redistributed routes.Access Control Lists (ACL) 293
