4Control and MonitoringThis chapter contains the commands to configure and monitor the system, including Telnet, file transferprotocol (FTP), and trivial file transfer protocol (TFTP) as they apply to the following Dell NetworkingS4810 platform.NOTE: Starting in version 8.3.10.0, the enable xfp-power-updates command was deprecatedfor the S4810. This command replaces the enable optic-info-update interval command toupdate information on temperature and power monitoring in the simple network managementprotocol (SNMP) management information base (MIB).asf-modeEnable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.S4810Syntax asf-mode stack-unit {unit-id | all} queue sizeTo return to standard Store and Forward mode, use the no asf-mode stackunit command.Parameters unit-id Enter the stack member unit identifier of the stack memberto reset. The S4810 range is from 0 to 11.NOTE: The S4810 commands accept Unit ID numbersfrom 0 to 11, though S4810 supports stacking of up to sixunits.queue size Enter the queue size of the stack member. The range is from0 to 15.Defaults Not configuredCommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version8.3.19.0Introduced on the S4820T.Control and Monitoring 91
