Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-port).CommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version 9.0.0.0 Added support for IPv6.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.management routeConfigure a static route that points to the Management interface or a forwarding router.S4810Syntax management route {{ip-address mask | {ipv6-address prefix-length}} {forwarding-router-address | managementethernet}To remove a static route, use the no management route{{ip-address mask| {ipv6-address prefix-length}}{forwarding-router-address |managementethernet} command.Parameters ip-addressmaskEnter an IP address (dotted decimal format) and mask (/prefixformat) of the destination subnet.ipv6-addressprefix-lengthEnter an IPv6 address (x:x:x:x::x format) and mask (/prefixformat) of the destination subnet. Enter the IPv6 address inthe x:x:x:x::x format followed by the prefix length in the /xformat.The range is from /0 to /128.NOTE: The :: notation specifies successive hexadecimalfields of zeros.forwarding-router-addressEnter an IP address (dotted decimal format) or an IPv6address (x:x:x:x::x format) of a forwarding router.IPv4 Routing 871
