show lldp neighbors — displays the LLDP neighbors.helloConfigure the rate at which the LLDP control packets are sent to its peer.S4810Syntax hello secondsTo revert to the default, use the no hello seconds command.Parameters seconds Enter the rate, in seconds, at which the control packets aresent to its peer. The rate is from 5 to 180 seconds. Thedefault is 30 seconds.Defaults 30 secondsCommandModesCONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)CommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.7.1.0 Introduced on the S-Series.Version 7.6.1.0 Introduced on the C-Series.Version 7.4.1.0 Introduced on the E-Series.management-interfaceEnable and configure LLDP protocol parameters on the management interface.S4810Syntax management-interfaceTo remove LLDP configuration on a management interface, use the nomanagement-interface command.1076 Link Layer Discovery Protocol (LLDP)
