show mac access-listsDisplay all of the Layer 2 ACLs configured in the system, whether or not they are applied to an interface,and the count of matches/mismatches against each ACL entry displayed.S4810Syntax show mac access-lists [access-list-name] [interface interface][in | out]Parameters access-list-nameEnter the name of a configured MAC ACL, up to 140characters.interfaceinterfaceEnter the keyword interface then the one of the followingkeywords and slot/port or number information:• For a Port Channel interface, enter the keyword port-channel and then enter a number. The C-Series and S-Series range is from 1 to 128.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet and then enter the slot/portinformation.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE and then enter the slot/port information.• For a VLAN interface, enter the keyword VLAN followedby the vlan id.in | out Identify whether ACL is applied on ingress or egress side.CommandModesEXEC PrivilegeCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.0.2.0 Introduced on the S6000.Version8.3.19.0Introduced on the S4820T.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.Version 8.4.1.0 Introduced.248 Access Control Lists (ACL)
