UsageInformationA DCB map is a template used to configure DCB parameters and apply them onconverged Ethernet interfaces. DCB parameters include priority-based flow control(PFC) and enhanced traffic selection (ETS).To display the PFC and ETS settings in DCB maps, enter the show qos dcb-mapcommand.Use the dcb-map command to create a DCB map to specify PFC and ETS settingsand apply it on Ethernet ports. After you apply a DCB map to an interface, the PFCand ETS settings in the map are applied when the Ethernet port is enabled. DCBx isenabled on Ethernet ports by default.The dcb-map command is supported only on physical Ethernet interfaces.To remove a DCB map from an interface, enter the no dcb-map map-namecommand in Interface configuration mode.priority-pgidAssign 802.1p priority traffic to a priority group in a DCB map.S4810Syntax priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-num dot1p3_group-num dot1p4_group-num dot1p5_group-numdot1p6_group-num dot1p7_group-numParameters dot1p0_group-numEnter the priority group number for each 802.1p class oftraffic in a DCB map.dot1p1_group-numdot1p2_group-numdot1p3_group-numdot1p4_group-numdot1p5_group-numdot1p6_group-numdot1p7_group-num568 Data Center Bridging (DCB)
