Version 9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.Version 9.0.2.0 Introduced on the S6000.Version 9.0.0.0 Introduced on the Z9000.Version8.3.19.0Introduced on the S4820T.Version 8.3.8.0 Introduced on the S4810.UsageInformationWhen you create a VLT domain on a switch, Dell Networking OS automaticallyassigns a unique unit ID (0 or 1) to each peer switch. The unit IDs are used forinternal system operations. Use the unit-id command to explicitly configure theunit ID of a VLT peer. Configure a different unit ID (0 or 1) on each peer switch.To minimize the time required for the VLT system to determine the unit ID assignedto each peer switch when one peer reboots, use this command.vlt domainEnable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.S4810Syntax vlt domain domain-idParameters domain-id Enter the Domain ID number. Configure the same domain IDon the peer switch. The range of domain IDs is from 1 to1000.CommandModesCONFIGURATIONCommandHistoryThis guide is platform-specific. For command information about other platforms,refer to the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version 9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.Version 9.0.2.0 Introduced on the S6000.Version 9.0.0.0 Introduced on the Z9000.Version8.3.19.0Introduced on the S4820T.Virtual Link Trunking (VLT) 1733
