NXP Semiconductors LPC43 Series User Manual

Contents

NXP Semiconductors LPC43 Series User Manual Manual pdf 260 page image

UM10503 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2012. All rights reserved.User manual Rev. 1.3 — 6 July 2012 260 of 1269NXP Semiconductors UM10503Chapter 14: LPC43xx Pin configurationPB_6 A6 C5 - [6] N;PU- R — Function reserved.I/O USB1_ULPI_D3 — ULPI link bidirectional data line 3.O LCD_VD13 — LCD data.- R — Function reserved.I/O GPIO5[26] — General purpose digital input/output pin.I CTIN_6 — SCT input 6. Capture input 1 of timer 3.O LCD_VD19 — LCD data.- R — Function reserved.AI ADC0_6 — ADC0, input channel 6. Configure the pin as GPIO inputand use the ADC function select register in the SCU to select theADC.PC_0 D4 - 7 [6] N;PU- R — Function reserved.I USB1_ULPI_CLK — ULPI link CLK signal. 60 MHz clock generatedby the PHY.- R — Function reserved.I/O ENET_RX_CLK — Ethernet Receive Clock (MII interface).O LCD_DCLK — LCD panel clock.- R — Function reserved.- R — Function reserved.I/O SD_CLK — SD/MMC card clock.AI ADC1_1 — ADC1, input channel 1. Configure the pin as GPIO inputand use the ADC function select register in the SCU to select theADC.PC_1 E4 - 9 [3] N;PUI/O USB1_ULPI_D7 — ULPI link bidirectional data line 7.- R — Function reserved.I U1_RI — Ring Indicator input for UART 1.O ENET_MDC — Ethernet MIIM clock.I/O GPIO6[0] — General purpose digital input/output pin.- R — Function reserved.I T3_CAP0 — Capture input 0 of timer 3.O SD_VOLT0 — SD/MMC bus voltage select output 0.PC_2 F6 - 13 [3] N;PUI/O USB1_ULPI_D6 — ULPI link bidirectional data line 6.- R — Function reserved.I U1_CTS — Clear to Send input for UART 1.O ENET_TXD2 — Ethernet transmit data 2 (MII interface).I/O GPIO6[1] — General purpose digital input/output pin.- R — Function reserved.- R — Function reserved.O SD_RST — SD/MMC reset signal for MMC4.4 card.Table 130. LPC4357/53 Pin description …continuedPin nameLBGA256TFBGA180LQFP208Reset state[2]TypeDescription