Audio Visual Bridging Commands 1086MVRP propagates VLAN registration information to allow switches in thenetwork to dynamically learn and configure VLANs. Refer to IEEE Std.802.1Q-2005 and IEEE Std. 802.1Qbe-2010 for further information. Inparticular, MVRP must also be enabled on the individual interfaces tobecome operational.MVRP does not support configuration of default group filtering behavior.MVRP does not support the optional Registrar Administrative Control forVLANs.If a VLAN is statically configured on an interface and MVRP requestsregistration (dynamic creation) of the VLAN, it is deleted and added back as atagged static VLAN. If subsequently deleted by the operator, the VLAN isdynamically created.If a VLAN is configured as forbidden on an interface and MVRP requestsregistration (dynamic creation) of the same VLAN, MVRP does not configurethe port association.MVRP is only supported on trunk or general mode ports.This command is only available on the N4000 Series switches.Command HistoryIntroduced in version 6.2.0.1 firmware.ExampleThis example enables MVRP globally.console(config)#mvrp globalmvrp periodic state machineUse this command to globally enable the MVRP periodic state machine. Usethe no form of the command to globally disable the MVRP periodic statemachine.Syntaxmvrp periodic state machineno mvrp periodic state machine
