Layer 3 Routing Commands 1599IPv6 Multicast CommandsDell EMC Networking N3000/N3100/N4000 Series SwitchesThe Dell Network N1500/N2000/N2100-ON series supports limited routing andmulticast capabilities. See the Users Configuration Guide section “FeatureLimitations and Platform Constants” for supported capabilities.This section explains the following commands:clear ipv6 mrouteThis command is used to selectively clear dynamic IPv6 multicast entriesfrom the cache.Syntaxclear ipv6 mroute { * | group-address [ source-address ] }* —Deletes all IPv6 entries from the IP multicast routing table.group-address— IPv6 address of the multicast group.source-address—IPv6 address of a multicast source that is sending multicasttraffic to the group.clear ipv6 mroute ipv6 pim sparse-modeipv6 pim (VLAN Interface config) ipv6 pim ssmipv6 pim bsr-border show ip mroute groupipv6 pim bsr-candidate show ip mroute sourceipv6 pim dense-mode show ipv6 pimipv6 pim dr-priority show ipv6 pim bsr-routeripv6 pim hello-interval show ipv6 pim interfaceipv6 pim join-prune-interval show ipv6 pim neighboripv6 pim register-threshold show ipv6 pim rp-hashipv6 pim rp-address show ipv6 pim rp mappingipv6 pim rp-candidate show ipv6 pim statistics
