Switch Management Commands 1825• max-megabytes — Set the maximum memory resource that theapplication process(es) are allowed to consume. Expressed as megabytesbetween 0 and 200. If 0 is specified, the application process(es) are notlimited. If this keyword is not specified, the default value is used. Thedefault is 0.Default ConfigurationBy default, no applications are installed.Command ModeGlobal ConfigurationUser GuidelinesApplication names may be up to 16 characters in length.The name specified in the application-name parameter must match thefilename output of the show application command exactly. Applicationnames are case sensitive.Command HistoryIntroduced in version 6.3.0.1 firmware.Exampleconsole(config)#no application install support-assistThis action will terminate the support-assist agent and remove it permanentlyfrom the switch. Are you sure you wish to continue (Y/N):application startUse the application start command to schedule an application for immediateexecution on the stack master.Syntaxapplication start application-name• application-name — The name of the application as shown in the showapplication command output.
