Layer 3 Routing Commands 1741ipv6 ospf transmit-delayUse the ipv6 ospf transmit-delay command in Interface Configuration modeto set the OSPF Transmit Delay for the specified interface.Syntaxipv6 ospf transmit-delay secondsno ipv6 ospf transmit-delay• seconds — OSPF transmit delay for the specified interface. In addition, itsets the estimated number of seconds it takes to transmit a link stateupdate packet over this interface. (Range: 1 to 3600 seconds)Default ConfigurationNo default value.Command ModeInterface Configuration (VLAN, Tunnel, Loopback) mode.User GuidelinesThis command has no user guidelines.ExampleThe following example sets the OSPF Transmit Delay at 100 seconds forVLAN 15.console(config)#interface vlan 15console(config-if-vlan15)#ipv6 ospf transmit-delay 100ipv6 router ospfUse the ipv6 router ospf command in Global Configuration mode to enableOSPFv3 and enter Router OSPFv3 Configuration mode. Use the no form ofthe command to disable OSPFv3 and remove the OSPFv3 interface andglobal configuration.Syntaxipv6 router ospf
