Layer 3 Routing Commands 1764Default ConfigurationThis command has no default configuration.Command ModeUser Exec, Privileged Exec mode, Global Configuration mode and allConfiguration submodesUser GuidelinesThis command has no user guidelines.ExamplesThe following examples display information about OSPF neighbors, in thefirst case in a summary table, and in the second in a table specific to tunnel 1.console#show ipv6 ospf neighborRouter ID Priority Intf Interface State DeadID Time--------- -------- ---- ----------- ------------- ----console#show ipv6 ospf neighbor interface tunnel 1IP Address..................................... 2.4.6.8ifIndex........................................ 619OSPF Admin Mode................................ EnableOSPF Area ID................................... 0.0.0.0Router Priority................................ 1Retransmit Interval............................ 5Hello Interval................................. 10Dead Interval.................................. 40LSA Ack Interval............................... 1Iftransit Delay Interval....................... 1Authentication Type............................ NoneMetric Cost.................................... 1 (computed)OSPF Mtu-ignore................................ DisableOSPF cannot be initialized on this interface.show ipv6 ospf rangeUse the show ipv6 ospf range command to display information about the arearanges for the specified area identifier.Syntaxshow ipv6 ospf range areaid
