Security Commands 910This example configures the switch to process and validate the Service-Typereceived in the Access-Accept message from the RADIUS server.console#confconsole(config)#radius-server host 4.3.2.1console(config-auth-radius)#attribute 6 mandatoryattribute 8Use the attribute 8 command to configure the switch to send the RADIUSFramed-IP-Address attribute in the Access-Request message sent to a specificRADIUS authentication server. The switch sends the IP address of the hostattempting to authenticate in the Framed-IP-Address attribute in the Access-Request sent to the authentication server.Syntaxattribute 8 include-in-access-reqno attribute 8 include-in-access-reqDefault ConfigurationBy default, the Service-Type is not included in the Access-Request messagesent to the authentication server.Command ModeRADIUS Server ConfigurationUser GuidelinesThere are no user guidelines for this command.Command HistoryIntroduced in version 6.3.0.1 firmware.Exampleconsole#confconsole(config)#radius-server host 4.3.2.1console(config-auth-radius)#attribute 8 include-in-access-req
