Layer 3 Routing Commands 1706User GuidelinesThe VRF identified in the parameter must have been previously created or anerror is returned.The VRF parameter is only available on the N3000/N3100/N4000 seriesswitches.ExampleThe following example displays the OSPF stub table.console(config)#show ip ospf stub tableAreaId TypeofService Metric Val Import SummaryLSA------------- ------------- ---------- -----------------0.0.0.1 Normal 1 Enableshow ip ospf trafficUse the show ip ospf traffic command to display OSPFv2 packet and LSAstatistics and OSPFv2 message queue statistics. Packet statistics countpackets and LSAs since OSPFv2 counters were last cleared (using the clear ipospf counters command.)NOTE: Note that the clear ip ospf counters command does not clear the messagequeue high water marks.Syntaxshow ip ospf traffic [vrf vrf-name]• vrf-name—The name of the VRF instance on which the commandoperates. If no VRF parameter is given, information for the default(global) router instance is shown.Default ConfigurationThis command has no default setting.Command ModePrivileged Exec mode, Global Configuration mode and all Configurationsubmodes
