Data Center Technology Commands 1162console(config-of-switch)#controller ipv4 1.2.3.4 port 3435 security sslhardware profile openflowUse the hardware profile openflow command to select the forwarding modefor the OpenFlow hybrid capability. Use the no form of the command toselect the default forwarding capability.Syntaxhardware profile openflow { full-match | layer2-match }no hardware profile openflow• full-match—Perform full matching when configured in OpenFlow 1.0mode.• layer2-match—Perform L2 matching when configured in OpenFlow 1.0mode.Default ConfigurationBy default, layer2 matching is performed.Command ModeGlobal ConfigurationUser GuidelinesThis command configures the switch when operating in OpenFlow 1.0 mode.It has no effect when operating in OpenFlow 1.3 mode.If the administrator changes the default hardware table for OpenFlow 1.0 andif the switch is currently operating in OpenFlow 1.0 variant then theOpenFlow feature is automatically disabled and re-enabled.OpenFlow operates on the stack master only. Flows may not be configured onstack members. Failover to the stack standby unit is not supported.OpenFlow should only be enabled on stand-alone switches and should not beenabled on stacks of switches. This restriction is not enforced.
