Switch Management Commands 2168no cut-through modeDefault ConfigurationThis command has no default configuration.Command ModeGlobal ConfigurationUser GuidelinesCut-through mode is only supported on Dell EMC Networking N4000 seriesswitches. It is not supported on Dell EMC Networking N1100-ON/N1500/N2000/N2100-ON/N3000/N3100-ON Series switches.Exampleconsole(config)#cut-through modeThe mode (enable) is effective from the next reload of Switch/Stack.disconnectUse the disconnect command to detach a UI session.Syntaxdisconnect { session-id | all }Default ConfigurationThis command has no default configuration.Command ModePrivileged Exec mode.User GuidelinesThis command forcibly logs out and disconnects a Telnet, SSH, HTTP orHTTPs session. Use the show sessions command to display the sessionidentifier.The session identifier ranges from 0-42. The all parameter disconnects alltelnet, SSH, HTTP or HTTPs sessions.
