Layer 3 Routing Commands 1644area virtual-link transmit-delayUse the area virtual-link transmit-delay command in Router OSPFConfiguration mode to configure the transmit delay for the OSPF virtualinterface identified by the area ID and neighbor ID. Use the no form of thecommand to return the transmit delay to the default value.Syntaxarea area-id virtual-link neighbor-id transmit-delay secondsno area area-id virtual-link neighbor-id transmit-delay• area-id — Identifies the OSPF area to configure. (Range: IP address ordecimal from 0–4294967295)• neighbor-id — Identifies the Router ID of the neighbor.• seconds — Number of seconds to increment the age of the LSA beforesending, based on the estimated time it takes to transmit from theinterface. (Range: 0–3600)Default Configuration1 second is the default configuration.Command ModeRouter OSPF Configuration mode.User GuidelinesThis command has no user guidelines.ExampleThe following example configures a 40-second transmit-delay interval.console(config-router)#area 10 virtual-link 192.168.2.2 transmit-delay 40auto-costBy default, OSPF computes the link cost of each interface from the interfacebandwidth. The link cost is computed as the ratio of a “reference bandwidth”to the interface bandwidth (ref_bw / interface bandwidth), where interface
