Layer 3 Routing Commands 1557Number of Active Areas ........................ Noneshow ipv6 routeUse the show ipv6 route command in User Exec or Privileged Exec mode todisplay the IPv6 routing table. The output of the command also displays theIPv6 address of the default gateway and the default route associated with thegateway.Syntaxshow ipv6 route [ipv6-address | ipv6-prefix/prefix-length | protocol |interface-type interface-number] [best]• ipv6-address—Specifies an IPv6 address for which the best-matchingroute would be displayed.• protocol—Specifies the protocol that installed the routes. Is one of thefollowing keywords: connected, ospf, static.• ipv6-prefix/ prefix-length—Specifies an IPv6 network for which thematching route would be displayed.• interface-type interface-number—Valid IPv6 interface. Specifies that theroutes with next-hops on the selected interface be displayed. Supportedinterface types are VLAN, Tunnel, and Loopback.• best—Specifies that only the best routes are displayed. If the connectedkeyword is selected for protocol, the best option is not available becausethere are no best or non-best connected routes.Default ConfigurationThis command has no default configuration.Command ModeUser Exec, Privileged Exec modes, Global Configuration mode and allConfiguration submodesUser GuidelinesThis command has no user guidelines.
