Layer 3 Routing Commands 1238no default-information originate Default Configuration• always—Allows BGP to originate a default route even if the commonrouting table has no default route.Default ConfigurationBy default BGP does not originate a default route. If a default route isredistributed into BGP, BGP does not advertise the default route unless thedefault-information originate command has been given. The always option isdisabled by default.Command ModeBGP Router Configuration modeUser GuidelinesOrigination of the default route is not subject to a prefix filter configuredwith the distribute-list out command.Command HistoryIntroduced in version 6.2.0.1 firmware.Exampleconsole(config-router)#default-information originatedefault-information originate (IPv6 AddressFamily Configuration)Use this command in IPv6 Address Family Config mode to allow BGP tooriginate an IPv6 default route.Syntaxdefault-information originate [ always ]no default-information originate Default Configuration• always—Allows BGP to originate a default route even if the commonrouting table has no default route.
