Layer 3 Routing Commands 1267console(config-router)# neighbor 2001::2 remote-as 65003console(config-router)# neighbor 2001::2 allowas-in 3neighbor connect-retry-intervalUse this command in to configure the initial connection retry time for aspecific neighbor.Syntaxneighbor { ip-address | ipv6-address [ interface interface-id ] | autodetectinterface interface-id} connect-retry-interval retry-timeno neighbor { ip-address | ipv6-address [ interface interface-id ] | autodetectinterface interface-id} connect-retry-interval• ip-address—The neighbor’s IPv4 address.• ipv6-address—The neighbor’s IPv6 address. If the neighbor’s IPv6 addressis a link local address, the local interface must also be specified. Theinterface must be a VLAN routed interface.• interface interface-id—A routing interface identifier (VLAN identifier).• autodetect interface interface-id —The routing interface on which theneighbor’s link local IPv6 address is auto detected. The interface must be aVLAN routed interface.• retry-time—The number of seconds to wait before attempting to establisha TCP connection with a neighbor after a previous attempt failed.Default ConfigurationThe default value is 2 seconds.Command ModeBGP Router Configuration modeIPv4 Address Family Configuration modeUser GuidelinesIf a neighbor does not respond to an initial TCP connection attempt, theN3000/N3100/N4000 Series switch retries three times. The first retry is afterthe retry interval configured with neighbor connect-retry-interval. Each
