Layer 2 Switching Commands 458Syntaxclear gvrp statistics [interface-id]• interface-id—An Ethernet interface identifier or a port channel identifierDefault ConfigurationThis command has no default configuration.Command ModePrivileged Exec modeUser GuidelinesThis command has no user guidelines.ExampleThe following example clears all the GVRP statistics information on interfaceGi1/0/8.console# clear gvrp statistics gigabitethernet 1/0/8garp timerUse the garp timer command in Interface Configuration mode to adjust theGARP application join, leave, and leaveall GARP timer values. To reset thetimer to default values, use the no form of this command.Syntaxgarp timer {join | leave | leaveall} timer_valueno garp timer• join — Indicates the time in centiseconds that PDUs are transmitted.• leave — Indicates the time in centiseconds that the device waits beforeleaving its GARP state.• leaveall — Used to confirm the port within the VLAN. The time is theinterval between messages sent, measured in centiseconds.• timer_value — Timer values in centiseconds. The range is 10-100 for join,20-600 for leave, and 200-6000 for leaveall.
