Layer 3 Routing Commands 1753ExampleThe following example enables OSPF traps.console#show ipv6 ospfRouter ID...................................... 0.0.0.2OSPF Admin Mode................................ EnableASBR Mode...................................... DisableABR Status..................................... DisableExit Overflow Interval......................... 0External LSA Count............................. 0External LSA Checksum.......................... 0New LSAs Originated............................ 0LSAs Received.................................. 0External LSDB Limit............................ No LimitDefault Metric................................. Not ConfiguredMaximum Paths.................................. 2Default Route Advertise........................ DisabledAlways......................................... FALSEMetric.........................................Metric Type.................................... External Type 2NSF Support.................................... DisabledNSF Restart Interval........................... 120 secondsNSF Helper Support............................. AlwaysNSF Helper Strict LSA Checking................. Enabledshow ipv6 ospf abrThis command displays the internal OSPFv3 routes to reach Area BorderRouters (ABR). This command takes no options.Syntaxshow ipv6 ospf abrDefault ConfigurationThis command has no default configuration.Source Shows source protocol/routes that are being redistributed.Possible values are static, connected, or RIP.Tag Shows the decimal value attached to each external route.Subnets When this option is not configured, OSPF will only redistributeclassful prefixes.Distribute-List Shows the access list used to filter redistributed routes.
